Modulo RF 2-in-1 M5Stack StickC Plus 1.1&2, supporta NRF24 2.4GHz e CC1101 433MHz con firmware Bruce, senza macchina

⚠ Important Notice | About “NRF24/CC1101 not found” If “NRF24/CC1101 not found” appears, this is a Bruce firmware compatibility issue, not a hardware problem. Solution: Flash Bruce Latest 1.14 firmware Check “Erase Device” during flashing (required) Reboot the device and reconfigure Images included: error screen / firmware selection / Erase Device option Compatible Device Models(Only support M5Stack StickC Plus,not support StickS3) ⚠ Note: This module is only compatible with M5Stack Stick Plus devices. Not compatible with M5Stack series. Please confirm your host device model before purchasing. See image: Compatible device on the left, incompatible device on the right. RF 2-in-1 Module for M5Stack StickC Plus1.1&2(Optional 3D Printed Case, Not included Machine) This dual-mode RF development board is specially designed for the M5Stack StickC Plus, integrating both A01-S2G4A00S2A (2.4GHz NRF24) and A07-S433A10S2A (433MHz CC1101) modules. Fully compatible with Bruce firmware, it features a plug-and-play design and supports both short-range and long-range wireless communication, making it ideal for IoT, wireless control, and RF development projects. 2-in-1 Module Key Features: ✅ Dual-module design: Supports both NRF24 (2.4GHz) and CC1101 (433MHz) communication ✅ Tailored for M5Stack StickC Plus, plug-and-play ✅ Bruce firmware compatible, no complex setup required ✅ High-performance RF communication for reliable data transmission ✅ Physical switch for easy module selection 2-in-1 Module Details: 2.4GHz NRF24 Module (A01-S2G4A00S2A): Stable, high-speed short-range wireless communication 433MHz CC1101 Module (A07-S433A10S2A): Low-power, long-range RF transmission Reliable performance with optimized signal layout and power design 2-in-1 Module Usage Instructions 1. Flash Bruce Firmware (First-Time Setup) To use this board with StickC Plus, first flash the Bruce firmware: Go to the official flasher: https://bruce.computer/flasher Follow the instructions to select the correct device (StickC Plus v1.1/v2) and complete the flashing process 2. Hardware Connection Connect the RF board to the M5Stack StickC Plus using the Grove cable or GPIO jumper wires The GPIO pinout is pre-configured and compatible with Bruce firmware 3. Switching Between Modules This board includes a physical switch to toggle between the two RF modules: To use the CC1101 (433MHz) module: 1. Toggle the switch to the 433MHz (CC1101) position 2. Navigate in the firmware: RF → CONFIG → RF MODULE 3. Select: CC1101 (legacy) To use the NRF24 (2.4GHz) module: 1. Toggle the switch to the 2.4GHz (NRF24) position 2. Navigate in the firmware: NRF24 → CONFIG → Pins 3. Select: NRF24 (legacy) 4. Additional Documentation For more advanced configuration and documentation, please refer to the official Bruce firmware Wiki: https://github.com/pr3y/Bruce/wiki/