
Vista completa
Articoli simili
Kit fai-da-te per amplificatore per cuffie HA5K FET in pura classe A/Scheda assemblata basata sul circuito dell'amplificatore Audio Tec-hnica HA5000
37,15€54,35€
Colore : Kit fai da te


Quantità :
Rapporto
Includere la violazione del copyrightSpedizione standard gratuita. Guarda i detagli
Stimato tra Thu, Jun 11 e Tue, Jun 16
Puoi restituire il prodotto entro 30 giorni dal ricevimento. Guarda i detagli
Acquista con fiducia
Garanzia di rimborso
Ricevi l'articolo che hai ordinato o ti verrà restituito il denaro. Saperne di più
Informazioni su questo articolo
Tratto da 3C electronics mall
Il venditore si assume ogni responsabilità per questa inserzione.Codice articolo: 37847409
Specifiche degli articoli
Condizione
Nuovo
Descrizione dell'articolo da parte del venditore
This is a Full Separate Pure Class A headphone amp. the circuit is base on the famous HA5000. the sound is very Excellent!!
Using Toshiba 2SK370 FET as a single differential input, sound is very delicate, K2955 J554 power FET as the output, low frequency is very full, very flexible.
On the amp Board with a gain switch, you can set the magnification depending on headset.
Works voltage: AC 15V--0--15V
Load impedance 16-600 Ohm
Sensitivity of 1.1 V / 50,000 ohms
Maximum output power
2,400 mW + 2,400 mW (16 ohm load)
1,200 mW + 1,200 mW (32 ohm load)
600 mW + 600 mW (64 ohm load)
65 mW + 65 mW (600 ohm load)
Input impedance: 47KOhm
Frequency characteristics: 10Hz - 35kHz
Signal ratio for noise: >90dB @ Gain 6dB
Output impedance: line output 0.2 Ohms
Frequency Response 5 ~ 200,000 Hz
PCB Size: 130mm*112mm
Debugging method:
1. Measure the TEST1A and TEST2A points, adjust the 2K blue adjustable resistor to adjust the voltage between DC 20mV and 80V. Please make sure to determine according to the temperature of your heat sink.
2. Measure the TEST1B and TEST2B points, adjust the 100R blue adjustable resistor to make the voltage close to DC 0mV.
NOTE: We have DIY kit or Finished board (Optional)
◆ DIY kit ---- All parts need you to solder and test it. (Without a potentiometer)
◆ Finished board ---- All parts have been welded and tested OK.















